Aprilia 2B007191 – Right Headlight Support for RSV4 1100

Aprilia 2B007191 – Right Headlight Support for RSV4 1100

The 2B007191 right headlight support is the genuine mounting bracket that secures the right side of the front lamp on RSV4 1100. Its precise geometry restores factory alignment after impacts, vibrations or wear, keeping the headlamp stable and the fairings perfectly seated. Designed to match original tolerances, it ensures direct plug&play replacement and a clean finish with no adaptation.

Why this part matters

Correct headlight alignment affects visibility, safety and the way the fairings close around the nose. A deformed or cracked bracket can cause beam misalignment, rattles, gaps between panels and premature wear of mounting points. Replacing the bracket with the original component brings back structural rigidity, eliminates play and protects the headlamp shell from stress.

Fitment & compatibility

• RSV4 1100 2021–2025 (USA 2026)

The fitment above groups models by family and years, avoiding market-specific variants. Always compare the code 2B007191 with the part label on your assembly for final confirmation.

What’s included

• 1 × RH front lamp support (2B007191).
• Mounting screws/clips are typically reused if in good condition; replace any damaged fasteners.

Installation guidance

• Remove the front headlamp and related fairings to access the support. Inspect all mounting points for cracks or deformation.
• Offer the headlamp to the bracket before final tightening to ensure neutral alignment (no stress on tabs).
• Tighten fasteners evenly; verify beam aim and re-check after the first ride.

When to replace

• Visible cracks, warped tabs or missing pieces on the right support.
• Persistent headlight vibration, buzzing noises or panel misalignment at the nose.
• Beam pointing off-center even after adjuster correction.

Benefits at a glance

• OEM geometry: perfect mating with headlamp shell and fairing panels.
• Stable beam: maintains correct aim and reduces vibration.
• Fast service: plug&play fit saves time during nose-cone repairs.

Tech notes

Use only suitable hand tools on plastic tabs and avoid over-torque on threaded inserts. If the left-side support is also damaged, replace it together to maintain symmetrical load on the headlamp assembly.