Aprilia 2B007192 – Left Headlight Support for RSV4 1100

Aprilia 2B007192 – Left Headlight Support for RSV4 1100

The 2B007192 left headlight support is the genuine mounting bracket that anchors the left side of the front lamp on RSV4 1100. Engineered to the same tolerances as the factory unit, it restores correct headlamp alignment after accidental impacts, prolonged vibration or wear on the original tabs. By matching the exact geometry of the nose assembly, it keeps the lamp shell firmly seated, preserves the designed gaps between fairings, and prevents stress that can crack the housing over time.

Why this part matters

On high-performance bikes, minor misalignment at the headlamp bracket translates into visible panel gaps, beam drift and buzzing at speed. Replacing a bent or cracked support with this original component brings back structural rigidity, eliminates play on the lamp pivots, and protects the surrounding fairing from resonance and premature wear. The result is a stable light beam, a clean front profile, and a nose cone that closes flush as intended.

Compatibility (grouped by model & years)

• RSV4 1100 2021–2025 (USA 2026)

What’s included

• 1 × LH front lamp support (2B007192).
• Fasteners/clips are normally reused; replace any worn or missing items during service.

Installation guidance

• Remove the nose cone and headlamp assembly to access the bracket. Inspect all tabs and threaded inserts.
• Offer the lamp to the new support and pre-align fairings before final torque to keep a neutral, stress-free fit.
• After reassembly, verify beam aim on a flat surface and recheck fasteners after the first ride.

When to replace

• Left-side tabs cracked or warped, or missing material on the support.
• Persistent lamp vibration, rattles near the windscreen area, or gaps between panels that won’t adjust out.
• Beam remains off-center despite adjuster correction.

Benefits at a glance

• OEM geometry for perfect mating with lamp shell and fairing panels.
• Stable beam and reduced vibration at speed.
• Plug&play replacement that saves workshop time and preserves factory finish.

Tech notes

Avoid over-torque on plastic inserts; use hand tools and follow workshop torque specs. If the opposite support is also fatigued, replace both to maintain symmetrical load on the headlamp assembly.