Thanks for purchasing the Aprilia-UpMap T800+!

Installation Procedure

1. Download & Connect:
   Download the UpMap App on your phone. Connect the T800+ to the bike diagnostic port using the supplied cable. Identify your cable type:
   • 2009-2020 (Cable “MARELLI”): Fits the flat black diag port under passenger seat. Connect the fused wire to the +12V battery terminal.
     
   • 2021+ (Cable “EURO5a”): Plugs into the red square diag port under the rider seat.
     
2. Pairing:
   Pair the T800 to the App following the App instructions and register your bike. The T800+ will recognize your bike model (in some cases VIN input is required).
   Note: The tool can only be paired to ONE bike and can’t be reset.
3. Map Download:
   First, download the Stock OEM map (this is your backup). Then go to the Map Store to find the ASpecialParts tuned map for your mods.
   🎁 FREE MAP COUPON:
   Use the code GRTMAP at checkout to download your tuned map for free! (Value: €118).
4. Flash the ECU:
   Follow the App instructions to flash the bike. The T800 will perform all needed adaptations at the end, asking you to cycle ignition on/off.
   ⚠️ CRITICAL WARNING:
   During the flash process:

   • Do NOT disconnect the App or T800.
   • Do NOT turn off the bike ignition.
   • Do NOT move the phone out of Bluetooth range.
   • Ensure both Phone and Bike batteries are fully charged (connect a charger if unsure).
5. Final Checks:
   After the reflash, check the dash electronics set-up (TC, AW, Engine Mode) and reset them to your preferred values. The T800+ can now be removed.

Follow us on Facebook and Instagram: @aspecialparts & @gabroracing